Haniwa 2

[donaud]

Pin does nothing for me. I can't get to the small slit anymore, and the large pink squares under the yellow arrows aren't letters (yet). Arrrgg.

How do you "get the letters" ?

[Falander]

I mean the 4 cubes then just put them under the arrows and make 2 words to open the doors and exit the room

[LadyLoveU]

where do you find the third block?

[donaud]

Lady, which ones do you have?

[LadyLoveU]

the one with HOPE, NEXT and EXPO ^^"

[donaud]

There's one...

under the blob, did you get that one ?

[LadyLoveU]

oh nvm.. thanks though?

[donaud]

Welp... I think I know what's SUPPOSED to happen.

Once you put all 4 of the blocks in the slit above the arrows, the letters should transfer below, and then you can change them with the arrows. I don't know what I'm doing wrong, but I've done it several times, even putting the blocks in, in order, but I never get letters below the arrows. Frusterating. I must have missed something (?)

[peach]

First time posting...hi

I'm at the same place you are. i have all the blocks in, but the arrows don't do anything when I push them and the letters from the blocks aren't there anymore. I also get an error message below them.

[donaud]

Just played it... AGAIN, peach. Sounds like you have the same problem I do. If I put 3 blocks in the top, and back out, I can see "H E I _" below the arrows. But when I put the last block in, they are all erased.

[Debidee]

I'm so rubbish...

How do I enlarge the small block and shrink the saw thing to make a key???

Help please???????????

[donaud]

Use the blue machine.

[peach]

I've started over twice already. Any info on what this "Po?" pin is? I'm completely confused on that one.

Debidee: did you charge the power source of the blue block?

[Debidee]

Use the blue machine.

Can't get the blue machine to do anything...is there something I need to open it? The button is in place.

[donaud]

The pin is for the "good" end. Not sure what to do with that either. I think the block letters is our bigger problem !!