Newtonian

[bagonow]

Most of the balloon levels were easier than the previous. The last one has me stymied. I have come close building a car with bars sticking forward to pry open the passage. Attached balloons and it nearly floated down to the landing spot but the bars (jaws of life, hehe) made landing impossible.

My brain is tired of that one.

5+ hours at least on the last one....have got it down twice, but no where close to the landing pad..........
My head needs a rest as well.


I noticed the "car" can go through the plunger but still no luck so far...

[Dogberry]

Level 39 is driving me insane!!

[RBS]

I must be insane but I am going back in for another try at 39.

[Adventure]

I am stuck on 39 since this morning. Not that I tried to solve it since then.

My first strategy was to get the vehicle over the green block. I managed to do this, but it didn't felt down in the yellow frame accurate enough. (picky game).

Same for my current method, using the ramp below. It's ends up in the yellow frame everything, but not accurately enough.

[Dogberry]

I have it using the above strategy. dont think I used those two balloons

EDIT: OMG nooooooo!!! thats the last level!

[bagonow]

Dogberry, can you show us your beginning set-up?

I'm wishing this car had 4X4..

Got it, thanks to Adventure's set-up, the front wheel and one balloon really took some tweaking. Dont know how to do a screen shot but thanks to all you guys for the help.

[Dogberry]

I think it is exactly as you see it. I don't know if I used one of those balloons rings to budge the car or if they weren't used at all.
I didn't expect it to work and tried so many different ways I can't remember which method I finally used lol

[RBS]

Brilliant! Both of you!. I did not ever try putting just the ring of a balloon under the cart, I always connected it to something.

WHEW!

[Adventure]

Can someone post the exact set up for 39? I really can't make it work when attaching both wheels to the vehicle thing.

[RBS]

I would Adventure but it will look EXACTLY like your post 79 only with the wheel moved slightly back to attach. The single balloon will slowly tug the whole car backwards until it falls off to the left. If the balloon tugs the wrong way you have to reset. It takes over 2 minutes for it to fall off.

[Adventure]

Thanks RBS!! I was still focusing to make the car flip. I got it working now. Only my bridge has to be altered a little because it crashes like a 0.1 second too soon.

Edit: Whohoo! Finally done!! Thanks for the help everyone!

[jack]

I got it to work with just one wheel like in Adventure's first post. It took numerous tries to get it to count though. The block bounced a bit at the end and got wedged just a tiny bit off of the ground.

[RBS]

That's great. Funny tho my bridge never fell. Unless those two extra balloons were intended to be red herrings I am sure there is another way.

[Adventure]

I got it to work with just one wheel like in Adventure's first post. It took numerous tries to get it to count though. The block bounced a bit at the end and got wedged just a tiny bit off of the ground.

I tried that method at least 20 times, but no luck. Also not when the block bounced a little up at the end.

That's great. Funny tho my bridge never fell. Unless those two extra balloons were intended to be red herrings I am sure there is another way.

My bridge didn't felt either after adapting it. It was just a matter of pixels.

I am very sure I solved many levels the unofficial way. I often left out parts, or the method I used was really very picky to make it work. I don't think the creator intended it that way.

[RBS]

After many attempts I got a solution just by placing the two bars on top of a two wheeled car. One bar popped onto the other bar and then the car popped on top of the two bars and drove across the plunger. Only problem is getting it to do it with any regularity. Usually the car gets stuck before crossing the plunger.

Still searching for the one fool proof method.